吊頂除濕機正確的安裝方法？
吊桿安裝，安裝前，要確定安裝位置，在確定的安裝位置用粉筆及量具進行準確定位后，再用鉆機在確定好的位置上鉆孔，打上膨脹螺桿，螺桿規格不小于M8。
Before the installation of suspender, the installation position shall be determined first. After the determined installation position is accurately positioned with chalk and measuring tools, the drill shall be used to drill holes at the determined position and hit the expansion screw. The screw specification shall not be less than M8.
除濕機安裝，在除濕機安裝之前需在四根膨脹螺桿上分別依次裝入四套M8螺母1，彈墊，平墊，再將除濕機水平向上移，以將膨脹螺桿穿入除濕機吊耳，再分別旋入一顆螺母2將除除機安裝在膨脹螺桿上，需注意除濕機在任何位置都不得倒置，否則除濕機將會損毀。
For the installation of dehumidifier, before the installation of dehumidifier, four sets of M8 nuts 1, elastic pad and flat pad shall be installed on the four expansion screws respectively, and then move the dehumidifier horizontally upward to thread the expansion screw into the lifting lug of dehumidifier, and then screw in a nut 2 respectively to install the dehumidifier on the expansion screw. It shall be noted that the dehumidifier shall not be inverted at any position, otherwise the dehumidifier will be damaged.
水平安裝，除濕機裝好后調整固定螺母，可用水平尺檢測，以使機身達到水平安裝，(以此保證除濕機可以正常出水，避免漏水隱患)，比較后螺母裝除濕機鎖緊，此時完成除濕機的安裝。
Horizontal installation, dehumidifier installed after adjusting the nut, can be detected with a horizontal ruler, so that the body to achieve horizontal installation, (so as to ensure that the dehumidifier can be normal water, to avoid water leakage), and finally nut installed dehumidifier locking, and then complete the installation of dehumidifier.
排水管的安裝，除濕機應高于排水管路5-250px，排水軟管長度根據實際情況來確定，但是請確保排水暢通。公司生產的吊頂除濕機既可以吸頂安裝，也可懸掛安裝。安裝完成后要便于維護，空氣循環流通。
For the installation of drainage pipe, the dehumidifier shall be 5-250px higher than the drainage pipe. The length of drainage hose shall be determined according to the actual situation, but please ensure smooth drainage. The ceiling dehumidifier produced by the company can be either ceiling mounted or suspended. After installation, it shall be convenient for maintenance and air circulation.
進風管安裝，進風口與機身應盡量接近，與除濕機本身的進風口高低位差盡量小，進風管道越短，除濕效果越佳。進風管比較長不可超過1.5m，與除濕機進風口需緊密連接(進風口前方不得有障礙物)。
For the installation of air inlet pipe, the air inlet shall be close to the machine body as far as possible, and the high-low level difference with the air inlet of the dehumidifier shall be as small as possible. The shorter the air inlet pipe, the better the dehumidification effect. The maximum length of the air inlet pipe shall not exceed 1.5m and shall be closely connected with the air inlet of the dehumidifier (there shall be no obstacles in front of the air inlet).
出風管安裝，出風口與機身的間距應盡量遠離，但出風管比較長不宜超過5米，與除濕機本身的出風口高低位差盡量小，與除濕機的出風口需緊密連接(出風口前方不得有障礙物)。
For the installation of air outlet pipe, the distance between the air outlet and the machine body shall be as far as possible, but the maximum length of the air outlet pipe shall not exceed 5m, the difference between the height and low position of the air outlet of the dehumidifier shall be as small as possible, and it shall be closely connected with the air outlet of the dehumidifier (there shall be no obstacles in front of the air outlet).
